ConeKilrAutoX
Member
- Dec 8, 2011
- 1,179
jeffro312 said:Hope i have no issues i love them what do you think?
looks great I like it !
jeffro312 said:Hope i have no issues i love them what do you think?
Mark20 said:On the way home at an intersection near work a Prius just kept creeping forward at the light. They were about halfway into the intersection. The lane ahead of him/her would end in a half block. I figure they wanted to get ahead of me before their lane ended.
Well the light turned green and I decided to see what the PCM 4 Less tune would do.
I left him way behind. And the cars behind also kept the pace up so he couldn't get out of the lane before it ended.
Mark20 said:On the way home at an intersection near work a Prius just kept creeping forward at the light. They were about halfway into the intersection. The lane ahead of him/her would end in a half block. I figure they wanted to get ahead of me before their lane ended.
Well the light turned green and I decided to see what the PCM 4 Less tune would do.
I left him way behind. And the cars behind also kept the pace up so he couldn't get out of the lane before it ended.
Mark20 said:On the way home at an intersection near work a Prius just kept creeping forward at the light. They were about halfway into the intersection. The lane ahead of him/her would end in a half block. I figure they wanted to get ahead of me before their lane ended.
Well the light turned green and I decided to see what the PCM 4 Less tune would do.
I left him way behind. And the cars behind also kept the pace up so he couldn't get out of the lane before it ended.
Sparky said:Use NA bulbs. The glass itself is amber not coated, so they'll never peel and turn white. Plus they tend to have a little bit richer color because of it.
ConeKilrAutoX said:I cut 5 inches off bumper and followed the angle in the corners to make room for the 30" intercooler + piping
View attachment 11738
-
Moved the 4x4 switch and rear wiper (don't use) to the glove box and moved some gauges to the center console.
The glovebox can fully close and open normally.
View attachment 11739
View attachment 11740 I just need to use black paint to paint around the gauges where I glued their holders
thank you! yes I will for sureFire06 said:That is going to look good. Make sure there are pictures when you are done
Black_tb said:I don't have any pictures but I finally got my switch back turn signals working today now to get another set of resistors for rear turn-signals
ConeKilrAutoX said:I removed the A.I.R. system fuses and relays and then I removed the A.I.R. system check-valve solenoid and pump. I cut out all the hoses and then used the A.I.R. block plate I bought from limequat.
SBUBandit said:Nice. I plan to do this this spring. I have the block plate already. Aside from the obvious hoses and the pump, what relays and fuses are related to the AIR system that you pulled out? Also, I'm assuming you don't have the factory intake anyways, so maybe your AIR system already was disconnected from the air box? I need to eventually find a stock air box that doesn't have the hold in the side for the AIR system.
Blckshdw said:Hopefully it's just a cabling issue