I figured it was just a matter of time. There is a lot going on getting this all up and running. The site is looking good.
Time to add more picts too. For the most part we have just been tearing it down and doing repairs where necessary. Also changed a few things around while it was torn apart.
So far this is what has been done.
Changed steering column to a tilt wheel setup
Added OEM power windows. Relocating switches to the console.
Replaced the old door popper solenoids with new Autoloc units
In the process of installing Viper 5901 alarm
2 runs of 2/0 power cable from the alt to rear battery bank
New starter cable from the battery bank to the starter
New bench seat from a Nissan pickup. Shaved all the hardware from the seats to lower the seat height.
Were in the process of rewiring some of the stuff in the rear. Fuel pump and sending unit. I added another Viair air compressor so running new wire for both and the pressure switch. Re running all the wiring to the switches and valves. Will also run some extra wires for any future additions.
View attachment 17136