So, there are only 2 torque specs > 150 lb ft on the truck--and both are LCA, right?

[6716]

And the lowest torque spec is 61 lb in?

So the range (LCA bracket mount bolts excepted) is about 5 to 150 lb ft.

Is there one decent torque wrench with this kind of range? Because as far as I can tell it looks like it will take 2 wrenches to cover all of that.

 

[The_Roadie]

2 is typical. One 3/8" drive, the other 1/2" drive.

 

[MAY03LT]

At work I have both, but at home I've only needed a craftsman 1/2" that does 20-150ft/lbs. Anything under 20 and I tighten it by hand and make a click sound myself.

 

[The_Roadie]

... I tighten it by hand and make a click sound myself.

I like that process. Without the click, the bolt won't *think* it's been properly torqued.

 

[Irishboy02]

make a click sound myself.

unfortunately i can picture you even adding a second click just for good measure

 

[Lima Tango]

I got a Mountain 25-250 ft/lb 1/2" torque wrench from Amazon for a little over $50 and it has served me well lo these many months. I don't have an in/lb one yet but am getting around to it; in the interim I will totally have to rip it and click it like advised above.