Hi All
When I use my Tech II I can calibrate the blend door motor, when I run the calibration I can hear motors in the dash turning and moving.
Can anyone confirm that the two actuator motors in the rear are also turning and calibrating?
Is this a one shot deal where all 5 of them recalibrate or is it front only and there no software routine for the rear motors?
I've got no heat in the back but the fan runs fine so I'm thinking a door isn't where it needs to be. I've ordered a new door motor but if I can calibrate the one that is there I can save $80.
JayArr
When I use my Tech II I can calibrate the blend door motor, when I run the calibration I can hear motors in the dash turning and moving.
Can anyone confirm that the two actuator motors in the rear are also turning and calibrating?
Is this a one shot deal where all 5 of them recalibrate or is it front only and there no software routine for the rear motors?
I've got no heat in the back but the fan runs fine so I'm thinking a door isn't where it needs to be. I've ordered a new door motor but if I can calibrate the one that is there I can save $80.
JayArr