Yes I did I change them all over to blue and you’re right maybe I did get some cider on there so I’m gonna pop it out check it out see if something is connected and I also have another 4 x 4 switch I’m gonna plug it in to see if that one does the same thing if there is no solder connection. Thank youI seem to remember you switching out bulbs to LEDs in and around your dash, is it possible that maybe you got some solder on there and may have bridged on to the other. I'd open up the switch and have a look.
I seem to remember you switching out bulbs to LEDs in and around your dash, is it possible that maybe you got some solder on there and may have bridged on to the other. I'd open up the switch and have a look.
Well it hasn’t crow hoped at all and I did go threw all the settings and the light stays on no matter what setting I have it on but I did not take notice of the 4 wheel was activating I wasn’t listening for it so I’ll do that today and see what happens. Thanks for the advice 😃You would have known of you did, crow hopping at every turn.
What does the light do when you change it to different positions? Do you hear the encoder motor and disconnect work as they should? If all's good except for that one light that stays on, is have to agree that it's likely a short.