2008 Saab 9-7x 4.2. I can't pass emissions testing because of code P2432 "Secondary air injection (AIR) system, air flow/pressure sensor, bank 1 - circuit low."
I have replaced the valve on the engine, the pump and relay under the car, and the relay in the front fuse box. The fuse is good. The problem, I imagine is in wiring or the PCM, but I have had just about enough.
I have read that the PCM can be told to not report the code, and I can install a block off plate where the valve mounts to the head. This seems like the most reasonable solution to me.
I know that I can mail the PCM to one or two places for this coding, but I am curious if the HP Tuner, Diablo Sport Tune, or some other device can do it as well? If so, I would much rather do it myself and have the equipment for other uses as well.
Does anyone know which programmers might be able to do this task?
I have replaced the valve on the engine, the pump and relay under the car, and the relay in the front fuse box. The fuse is good. The problem, I imagine is in wiring or the PCM, but I have had just about enough.
I have read that the PCM can be told to not report the code, and I can install a block off plate where the valve mounts to the head. This seems like the most reasonable solution to me.
I know that I can mail the PCM to one or two places for this coding, but I am curious if the HP Tuner, Diablo Sport Tune, or some other device can do it as well? If so, I would much rather do it myself and have the equipment for other uses as well.
Does anyone know which programmers might be able to do this task?