Hey guys! My work truck my company gave me (2013 Silverado 5.3) just had its engine pulled because the lifter took a shit. (AFM at its best). Well. They let me have the motor they pulled. It’s sitting in my garage and I’m getting ready to tear it down. I honestly doubt there is any metal in the pan from the lifter pounding against the cam since it only did it for less than 15 minutes of driving before it went to the shop. Anyway, I’d like to rebuild this entire motor and put it into hopefully an old s10 or something I can pick up cheap. I would try to get 500 horsepower out of this motor but with the spur of the moment it was offered to me, I have no previous knowledge of this specific 5.3 other than it’s LS based. So where should I start with the rebuild process? I’m trying to get a plan going I guess. Sorry for being so vague.