I cleaned my throttle body which was FILTHY, could have used a chisel on the buildup, and gave the MAF a good clean too. Everything improved, but when I start up and let the truck idle for a few minutes, it goes sorta sputtery and rough until I hit the accelerator. It hesitates for a split second then takes off just fine...
I followed a few YouTube tutorials to do the cleaning, and pulled the PCM fuses rather than disconnecting the battery... I had the fuses out as long as it took me to dissasable, clean, and reassemble everything so that should have been long enough, surely? The clock and stereo etc. didn't reset though...
Did I miss anything important? Anything I should check? Anything else I should clean?
Thanks for advice...
I followed a few YouTube tutorials to do the cleaning, and pulled the PCM fuses rather than disconnecting the battery... I had the fuses out as long as it took me to dissasable, clean, and reassemble everything so that should have been long enough, surely? The clock and stereo etc. didn't reset though...
Did I miss anything important? Anything I should check? Anything else I should clean?
Thanks for advice...