Two screws. What could go wrong. Turned in to a PITA. Removed screws and attempted to remove the little plastic latch. The lid inner liner flexed a bit and was finally able to pull it out but would not go back in. Had to pull all items from the box, remove 6 screws to remove box because the back lip of box was 50/50 over the top of the middle 7mm screw that held down the front part of the lid hinge. Then disassembled the lid screws and found the "locating nubs" that lined up the latch piece. Got it all back together and the lid would not close square to allow the latch to align with the hole where latch closed at. Had to loosen all 6 of the hinge screws and wiggle to just the right spot and then re-tension and now can just give a slight nudge to the lid and it closes and latches easily. Two screws turned in to 16 screws. But, it is "By-God" done!!!!!!
I can't wait for her to take off to Seattle for the Mother's Day weekend so I don't have to think about what to do next to that TB.
I can't wait for her to take off to Seattle for the Mother's Day weekend so I don't have to think about what to do next to that TB.