C
c good
Hobbyist 67
Latest Activity Postings About
-
-
Cc good replied to the thread Since the 2002 4.2 came with an oil level and oil temp sensor....So.....it IS both a temperature sensor and an oil level sensor after all! Does anyone know what kind of warning I would get or if it would drop into "Limp' mode when oil temps are outside...
-
Cc good replied to the thread Since the 2002 4.2 came with an oil level and oil temp sensor....Somewhere I saw it was both an oil level and temperature sensor but it looks like it's only an oil level sensor. I couldn't find anything mentioned in my owners manual either.
-
Cc good replied to the thread Adding a real oil pressure gauge. Digital or Analog? What PSI range?.Thank you for the feedback and the links all. I have the adapter in the front in place and temporarily plugged until I decide on a gauge and mount. I have been looking for a blue tooth type...
-
Cc good reacted to Mooseman's post in the thread Adding a real oil pressure gauge. Digital or Analog? What PSI range? with
Like.
From others here and on YT videos that have connected a mechanical gauge, pressures can go as high as 80 psi when cold and settle back down to 60 psi hot at driving RPM depending on how old and... -
Cc good posted the thread Since the 2002 4.2 came with an oil level and oil temp sensor... in Technical Discussion.Where will I get a notice and what kind of notice will it be for temperature?
-
Cc good posted the thread Adding a real oil pressure gauge. Digital or Analog? What PSI range? in Technical Discussion.Finally adding a true oil pressure gauge. I don't want to run an oil line into the Envoy so am going with a wired one. Would you go with a digital or analog style? What P.S.I. range? 2002 4.2
-
Cc good replied to the thread Low oil pressure warning again...only when pulling my small trailer..Hi Mooseman, I did put an oil pressure gauge on it a few years ago when I first had the problem. It was a temporary hand held type that I ran the hose up to the windshield and could watch while...
-
Cc good posted the thread Low oil pressure warning again...only when pulling my small trailer. in Vortec 4.2L I-6.I thought I had the problem solved. Berrymans crankcase soak, new pressure switch, Valvoline R&P. Etc.....I hadn't towed my 2000 lb trailer in two years. With all of my driving to the desert...
-
CDiagnosing a Fuel Pump begins with taking a Fuel Pressure reading as per: ...and continues with Dynamic Testing while the Fuel Pump is Running at Engine Idle and through Various RPM Ranges that...
-
CIf you do decide to go ahead with replacing the pump, it is strongly suggested to use only an ACDelco or Bosch (Bosch makes them for ACDelco so whichever is cheaper). Delphi pumps have been...
-
C207k miles on what I believe is the original fuel pump. Envoy still running perfectly. No abnormal noise from the pump. Installed a new filter last year and everything looks good. How long do...
-
Cc good replied to the thread Filter screen under oil pressure switch?.Thanks for the replies all. Sorry Mooseman for the double post. I couldn't find the previous post this morning. I thought maybe it got lost. I didn't look in the technical section. 😃
-
CThis has been answered here.
-
CIs there a filter screen under the oil pressure switch? 2002 Envoy 4.2
-
Cc good reacted to movietvet's post in the thread 3 hour Battery Replacement. What a P.I.T.A. with Like.
The factory crimp on the cable end in pic #4 does not pass muster. I saw one like that recently and did a cut off of the eyelet and cleaned far back in the insulation and then crimped back with a...
-
Cc good reacted to Mooseman's post in the thread 3 hour Battery Replacement. What a P.I.T.A. with Like.
Those side terminals were garbage when they introduced them in the 70's. Proof they were a failure is they are now back to top posts. Took them over 30 years to admit it.
-
CI've been hearing about a fine screen that is under the oil pressure switch. While my Envoy is doing good after my new pressure switch, a Berryman's Crankcase soak, and running Valvoline Restore...
-
COld battery 5 years old finally gave up the ghost. What should have been a ln easy swap turned into a 3-4 hour ordeal. The positive battery cable was replaced around 2.5 years ago. Brand new...
-
-
CI am going to install the Firestone air bags inside my stock coil springs. 2002 GMC Envoy, 4x4. The instructions show the air lines going out of the bottom. I see that as a potential problem...
-
CProbably not unless you start running a turbo or making tons of extra power. Watched a video from Atlas Industries and even they said that if it's properly maintained and not modified, the stock...
-
CI'm seeing these supplemental oil feed line kits for my 4.2 Atlas. They take oil from accessory port in front by the oil filter and run it to the back of the block to add additional oil supply...
-
Cc good reacted to Mooseman's post in the thread Sea Doo and trailer. Approx 1300 lbs. Tow in 3rd? with Like.
I'd try it in D and see how it acts. Probably will still need to downshift to 3rd going up grades or you notice it hunting between 3rd and 4th. Headwinds can also affect towing.
-
Cc good replied to the thread Sea Doo and trailer. Approx 1300 lbs. Tow in 3rd?.I do have the GU6/3.42 ratio diffs.
-
Cc good reacted to TollKeeper's post in the thread Sea Doo and trailer. Approx 1300 lbs. Tow in 3rd? with Like.
I guess it would depend on the terrain and gearing. If you have the GU6 gearing, I would tow in 3rd. If you are noticing the transmission shifting more than it would normally, put it in 3rd.
-
CI know everyone recommends towing in 3 rd for trailers in general. I recently purchased an older Seadoo and trailer. Combined Weight is at most 1300 lbs. I have a PCM of N. Carolina auxiliary...
-
-
Loading…
-
Loading…
