Male Connector On Tail Light Board

[Zapp Brannigan]

Edit: May have found some more information in this post here.

So I have found that the wiring connector that goes from the vehicle TO the tail light board is either an AC Delco PT1554, or PT1555.

I am doing a Mod (if I ever get around to it), as seen here in this thread, and I want to directly wire some LED Emergency Warning lights into the vehicle wiring, but using an adapter with pigtail, instead of cutting into vehicle's wiring.

Does anyone know the Part Number to the male end, on the back of the tail light boards? I have searched the OS as well as here to no avail, seen here below from an old thread.

I searched the AC Delco Catalog and think maybe PT1694:

...or PT1658?

Thank you all in advance for your assistance!!!

 

[Zapp Brannigan]

Ok, so after finding a post in this thread, I the previously mentioned links are Pigtail combinations, the actual CONNECTORS themselves, may be Delphi GT 150 or GT 280. I guess the internals are the difference, inside the connector.

 

[stickypoop]

Not sure if it helps, but the Ascender tails use the connector you're after

edit: that was in reference to envoy... not sure if same for tb. Posted without brain

 

[Blckshdw]

Back when I was considering doing a similar mod, I bookmarked this link, that was shared on the forum many years ago, as a source for the connectors.

http://www.bmotorsports.com/shop/product_info.php/cPath/109_130_197/products_id/1486

 

[Zapp Brannigan]

Back when I was considering doing a similar mod, I bookmarked this link, that was shared on the forum many years ago, as a source for the connectors.

http://www.bmotorsports.com/shop/product_info.php/cPath/109_130_197/products_id/1486

Thanks!! Narrowing it down now, I just have to decide if I want to get a pre-made pigtail unit with the correct connector, or just get the connector and go from there!!

 

[coolasice]

From service manual is 5-way GT 150 Series Sealed