Recent content by Babas11911

I didnt take the fuse box apart with the battery connected I took the seats out and the bolts loose. I havent done anything I shouldnt with the battery connected. I dont think its possible to test the wires for voltage with the battery disconnected.

The fuse box is getting good power to it so how can i remedy the connectors? Should i take the fuse box apart i have it loose and when i was shifting it to get to my wires the interior lights were flashing on and off too!

Well the guy that was helping me accidentally cut the line so when i went to repair it i tested it first just to see and thats what i got.

So at the two fuses I am getting right around 12v but when I splice the line about a foot above the fuse box going to the lights I was only getting 0.32. So any ideas?

Ok so i should start at the rear fuse panel and trace it to the rear?

Ok lol what is it then cause dude at advance lied to me

Oh and I dont have power in any of the brake lights. I dont know about the third but I disconnected it to see if they would work cause I think that bulb is blown. I cant get that third light assembly apart. Its a pain I got it out of the joint but the whole piece comes how can I get to the bulb...

Well i have power at all the fuses including 34 so i have taken my seatsz out and i am going to trace the wires because I got nothing in my tail lamp circuits. Do I need to check where the wires r running out of the fuse box?

I have a test light and a meter the fuses are good and the electrical in the box i checked the third light which doesnt work but the fuse is good and so is the voltage. I disconnected it. Anyways i have checked 12 under the hood the one for the third and every thibg else. I checked the plug to...

Ok my brake lights are not working. I first checked the fuses they are good. Then I checked the bulbs and they were good. I then changed the circuit board and they were good and that didnt fix my problem. So my next step was to change the switch on the brake pedal and that didnt work either...

I got it in and im almost done now! Only thing left is putting the bellhousing back on and the torque converter then putting the transmission in. I am so glad not bad for MY FIRST TIME ALONE!:wootwoot:

Yea maybe but part of the time im on my computer n part on my phone n i dont kno how to get to my previous stuff havent had time

So I got the oil pump and go to put it back in and the damn thing gets like half way and stops any ideas.?????

I need to get a transmission repair manual. Where can I find one?

So we put our new engine in which runs great and we put the torque converter in turned it three clicks so we know its right. Everything is hooked up right. When we put it in gear it will not move at all. I know the transmission ran when we first got it and now I cant figure it out. Please any Ideas?