free advice. wet the seal at the top of the resevoir cap and make sure to leak check the seal prior to putting brake fluid in the motive.
(pressurized leaking brake fluid will mess up the fine paint job inside your engine compartment and make a mess of your driveway.) don't ask me how I know.
Seriously.....I think this was one of the easier procedures to do....anyone on the fence about doing this.....DONT BE......First time brake bleeder here. Watch the videos a couple of times...take meerschm's good advice and do it.
Does it make me a bad guy if I talk a little junk around the neighborhood about how I just bleed my brakes to sound like I actually have a mechanical clue?
When in reality I don't but I am a "paint by the numbers" fool thanks to GMT Nation?:wootwoot: