- Aug 8, 2012
- 79
I'm over at the in-laws and noticed the selector switch was reading 4hi. The switch is in 2hi. It doesn't feel like it is in 4wd. The switch blinks 2hi when I put the switch to 4hi then back to 2hi. I don't hear whirling sounds either front or middle. I have already replaced the tcm with a 2003. I also tried pulling both fuses and swapping them with spares. When selected it will go to auto but when try to put it in 4lo or 2 hi it flashes there and then quits and stays in 4hi. No service 4 wheel drive light. I have been using 4wd a lot the last 3 weeks without issue.
Any ideas that I can try without tools or test equipment?
Thanks,
Walt
Any ideas that I can try without tools or test equipment?
Thanks,
Walt