Another actuator thread
- Thread starter ttcfan4476
- Start date
Sparky
Member
- Dec 4, 2011
- 12,927
Those 4 all for the same position, or different ones (driver side blend, passenger blend, defrost, etc)?
Did everything just die all the same time on you suddenly?
Not sure if they share a common connection point (like power and/or ground) but I'd check for that.
I'd replace one of the bad ones first that's easiest to get to, and see if that starts working. If it does, then replace the rest.
Did everything just die all the same time on you suddenly?
Not sure if they share a common connection point (like power and/or ground) but I'd check for that.
I'd replace one of the bad ones first that's easiest to get to, and see if that starts working. If it does, then replace the rest.
I'm not sure of the status of when they died. I just got the tb running after a engine swap. trying to get the "small" things fixed now. they are from drivers and pass heat cold doors and defrost and vent floor.
Matt
Member
- Dec 2, 2011
- 4,022
I've had one die twice but in between had another one go, then the last one on the drivers side. So, I've replaced all three on the drivers side within a 3 month period.
Mooseman
Moderator
45 bucks. They seem to be well built. It looks identical to the new gm ones.
Who knew I could use big truck parts for my Trailblazer.
I know the two types of actuators are the S and R used in the TB. I didn't know a YC could substitute for the S actuator. Good to know......
And it is possible to have several bad actuators at once - the originals are poorly designed. Hopefully the new ones are better
Tiggerr
Member
International trucks use quite a few gm parts... at least the older ones did..
Even their ignition keys were the same as gm keys for yrs...
Even their ignition keys were the same as gm keys for yrs...
I was looking thru the shelves at work Friday and I found another actuator that looks right but it only has 4 pins all on the left side of the connector. All of mine that I pulled out were 5 pin, 3 on right 2 on left.
Mooseman
Moderator
Just checking to see if these actuators are working well. Need to get some for my son's Silverado.
Mooseman
Moderator
Excellent because they seem to be way cheaper than anything else. I'll see if I can get them from a truck parts supply shop. I'll probably buy a spare for the eventual failure in mine.
Also added this thread to the FAQ.
Also added this thread to the FAQ.
Not to hijack your thread, but along the same line of questioning. Does anyone know the proper part # for the defrost mode actuator for a 2002 envoy sle with manual dual slide controls?
- Jul 22, 2015
- 2,724
You can find that here (and a few other places on this site): https://gmtnation.com/forums/threads/so-can-i-use-this-actuator.14836/#post-482821
Has anyone tried to use the Passenger Side Actuator on the Drivers side? They look identical and was just wondering if they are interchanable and if anyone has tried. There are 5 of them. The only one with 3 pins is the Recirculation one. All the rest have different part numbers but internally look the exact same. Just wondering if anyone has tried to interchange them and to what success or failure they encountered.
Mooseman
Moderator