Recent content by jpinoy

Saw someone post this on FB, thought it was funny...

I officially hit 200K the other day... now for a good tune-up/maintenance to keep her running like new as my DD...

I've been using https://www.gm-trucks.com since I bought my 2017 Silverado. I'm on there a lot(which is a bad thing for mods/aftermarket add-ons.. haha) Another one is https://www.silveradosierra.com, which I don't frequent as much as I did at the start.

Thanks! The sad thing about getting the LTZ trim, there isn't that much to 'mod'. I find myself reading others post on how to upgrade/mod parts of their truck, that I already have as part of the trim package... the mod bug in me wants to do stuff to the truck.. lol..

Installed a ODB II splitter on my Silverado and modded it with an on/off switch so I can turn my AFM Disable off when not in use, hate the sound of V4 mode. :biggrin:

Finally picked up a new ride back in Feb. New 2017 Silverado 1500 LTZ DC. Oh, still have my '06 TB, my wife drives that now. :D

This sounds similar to what happened to me a while back. The gauges would seem to be resetting(dropping down when turning the key) and nothing from the starter(noise of any sort). Every turn of the key, it seemed my gauges were calibrating. Turned out, I blew Fuse 22 in my Fuse block in the...

Yes, on the alignment with the new tires. I rolled the front tires that were going to the back around the driveway before putting them on and they rolled straight, no wobble and I couldn't see anything that showed abnormal wear.. but eh... like I said, I was planning on new tires in 2/months...

The humming noise on mine is in 2wd/4-hi, so it didn't make a difference which one I was in, the noise was there. Today I rotated the tires and the noise seemed to have went to the rear. The noise was still there, but was not as loud like before rotating the tires. Had my wife sit in the back...

Yes, the noise matches the speed of the vehicle. At a full stop there is no noise(with hitting the gas, you just hear the engine rev normal) and after going pass.. say.. 30mph.. that's when I start hearing the noise pretty good and it's really noticeable.. and the sound gets less after say...

I just actually took it out after reading your comment and switched it to Auto.. .same noise... switched it to 4-hi same noise, but not sure if it was me, didn't sound as loud, but noise was still there.. there is one issue I didn't like... I pulled over and switched it through all the...

So, for an update... I ended up replacing both cv axles. First was on passenger side where the noise was really noticeable. Noise really didn't go away, was still there with acceleration/deceleration. Replaced the drivers side cv axle, and noise is still present.... When I took out the...

Ah, ok. I'll check them out, seems to be in the same ballpark in price as Cardone. Thanks!

Yeah, I didn't think the stabilitrak came on before with my old module/disconnect when I did engage it, might try swapping out to my old one and see if it reproduces. I was thinking the u-joints as well.. as I head some clicking noise today when doing hard turns(left). Recommendations on a...

So, I replied on someone else thread and mentioned this in my reply, but wanted to get this out here just in case.. did a search and didn't really see anything that match my problem/question... wrong key words in search? I just replaced my axle disconnect, long story short, trying to figure out...