Hey guys. Just me again. I'm going to include two pictures here where I see what appears to be too much oil on connectors and wires. I am likely using the wrong word of connector so what I'm referring to is the light colored piece where wires are going in/coming out. Notice how the wires seem to be oil covered too. I noticed the check oil dipstick is in this area so perhaps someone was sloppy and it's just from many oil checks over the years and nothing is truly leaking and I just need to clean it up? I'm not really sure what to expect in this area.
Reason I'm asking is because this used to have a lot more oil on it 6 days ago. It was completely black and when I wiped it off with some paper towel, I miraculously had p0340 which was pending and never confirmed go away. I thought oh this must be having to do with the camshaft sensor. Maybe it shouldn't be this dirty etc etc. Since then though, the code has returned so was probably just the fluke but I am still wondering how much oil on this area is normal versus signifying a problem. I will be addressing p0340 but would appreciate a response to this.
Reason I'm asking is because this used to have a lot more oil on it 6 days ago. It was completely black and when I wiped it off with some paper towel, I miraculously had p0340 which was pending and never confirmed go away. I thought oh this must be having to do with the camshaft sensor. Maybe it shouldn't be this dirty etc etc. Since then though, the code has returned so was probably just the fluke but I am still wondering how much oil on this area is normal versus signifying a problem. I will be addressing p0340 but would appreciate a response to this.